Solar Productions Porsche 908/2 and "McQueen" Porsche 908/2
About this time last year I started building three Trans Am Camaros at the same time. It turned out to be a lot more work than I expected, yet here I am again doing something similar. With a little luck I'll have these two done by the next 24 Hours of Le Mans.
1/43rd scale Starter resin kits. The basic clean-up and scribing have been done and the brass winglets have been fitted to them.
The rear frame is PE brass in both kits, but not the same configuration. The one for the Solar camera car is on the right. It was very fragile so I soldered it up for strength. The other one seemed to be made from a much stiffer brass even though they are both the same thickness.
The roll bars are bent from wire provided in the kits. I could not get solder to work with them so I used CA to hold the two pieces of each one together.